home page

Swimming Pool Waterproofing
ApcoBuild SureSeal Plus
  • Surface to be treated should be sound, clean and free from dirt, oil and other loose material.
  • All the surface cracks, undulations and voids must be repaired appropriately before application.
  • Surface should be in SSD condition prior to application.
  • Mix the ready to use ApcoBuild Sure Seal Pus two component system in the ratio of 1:1 by adding powder under stirring with low speed mechanical stirrer into the liquid to avoid the lump formation and to obtain uniform dispersion of powder.
  • Allow the mixed slurry to stand for 5 – 10 minutes for releasing trapped air during mixing.
  • Apply 2 coats of material as prepared above with intermediated drying of 4-6 hours. Ensure freshly prepared material as above is used for second coat and applied in the direction perpendicular to the first coat and allow it to air cure for at least 72 hours.
  • Do not dilute with water nor do add any cement or powder.
  • Always add powder to liquid and never add liquid in powder.
  • Allow 1st coat to dry completely for 6 – 8 hrs before applying 2nd coat.
  • Allow the coating to dry completely for 3 days after 2nd coat for the complete air curing.
  • Protect the coating with proper mortar screed for best performance over the years.
>Download Pdf Files
More resources > > >
Disclaimer: These suggestions and data are based on information which we believe to be reliable. They are given for information only and in good faith, but without guarantee, as conditions and methods of use of our products are beyond our control. We recommend that the user determines the suitability of our materials and suggestions before adopting them on a commercial scale.